130 watts output power single output universal 90-264vac input 5vdc to 48vdc outputs 4242vdc input to output isolation active power factor correction model number output v output i max. ripple & noise effciency(min/nom) capacitive load single output pmk130s-5 (u)(-a) 5 vdc 22 amps 100mv pk-pk 75% / 80% 10,000uf pmk130s-12 (u)(-a) 12 vdc 10.8 amps 120mv pk-pk 80% / 82% 26,800uf PMK130S-15 (u)(-a) 15 vdc 8.7 amps 120mv pk-pk 80% / 85% 22,000uf pmk130s-24 (u)(-a) 24 vdc 5.4 amps 120mv pk-pk 82% / 85% 28,000uf pmk130s-28 (u)(-a) 28 vdc 4.6 amps 120mv pk-pk 82% / 85% 16,800uf pmk130s-36 (u)(-a) 36 vdc 3.6 amps 120mv pk-pk 82% / 85% 1,950uf pmk130s-48 (u)(-a) 48 vdc 2.7 amps 120mv pk-pk 82% / 85% 7,800uf note: 1. the pmk130 series is offered in an optional u-channel chassis as well as with optional 3.96mm pitch 5 and 10 pin input and output connectors (open frame construction and screw terminals are standard respectively). simply add a u at the end of the model number to recieve the u-channel confguration or a -a to receive the pins, or both if both are desired. for example: the model number pmk130s-5u-a represents a single output 5vdc u-channel supply with 3.96 pitched pins (5 input; 10 output) . see the mechanical dimensions on pages 3 through 8 in this specifcation 2. all u options are not covered by ul certifcation unless provided with more than 10 cfm forced air cooling applied 6-10cm above t1. 3. derating curves acceptable up tp 40c for ul certifed products 3 x 5 x 1.4 * these are stress ratings. exposure of the devices to any of these conditions may adversely affect long term reliability. proper operation under conditions other than the standard operating conditions is neither warranteed nor implied. all specifcations are typical at nominal input, full load, and 25c unless other - wise noted www.astrodynetdi.com astrodyne usa: 1-800-823-8082 astrodyne pacific: 886-2-26983458 pmk130 series 130w open frame and u-channel power supplies with pfc
input specifications input voltage range 90-264vac (100-240vac nom.) input frequency range 47-63 hz inrush current, typ: cold start, 60a @ 230vac input * input current 2.3~0.8a (90-264vac) power factor (cold start) pf > 0.96 @ 230vac leakage current <3.5ma @ 264vac, 50hz output specifications voltage and current see selection chart maximum output power 130 watts preset accuracy (note 6) 1% line regulation (note 5) 0.5% nom / 1% max load regulation (20% to fl) 0.5% nom / 1% max ripple/noise (notes 1,2,7) see selection chart turn on <4s, typ. hold up time 20ms, typ. rise time 30ms, typ. short circuit protection auto recovery * over voltage protection 130% max., auto recovery * over current protection 150% max., auto recovery * transient response 10ms over shoot/under shoot <10% of nominal o/p vdc general specifications safety ul/cul: ul60950-1 2nd ed./ c22.2 60950-1 2nd ed. ul-eu: en60950-1 2nd ed. ce: en60601-1-2 cb: iec60950-1 2nd ed. isolation (note 3) 4242vdc i/p - o/p * 2828 vdc i/p - gnd * 707vdc o/p - gnd * insulation resistance 20m? (500vdc, 1s i/p-o/p) emi cispr en55011 class b effciency see selection chart environmental specifications oper. temperature (note 4) -10c to +70c (see derate curve) storage temperature -25c to +85c relative humidity 10 to +90%, non-cond * ems harmonics: iec61000-3-2 class a fluctuations: iec61000-3-3 esd: iec61000-4-2, 6kv contact, 8kv air rs: iec61000-4-3 fr: 80mhz-2.5ghz field strength: 3v/m eft: iec61000-4-4 2kv on ac line surge: iec61000-4-5 1kv (l-l); 2kv (l, n-pe) cs: iec61000-4-6 3v (emf) dips: iec61000-4-11 95% 250cy, 70% 25cy, 40% 5cy, 5% 0.5cy mtbf 197,000 hrs min. mil-hdbk-217f vibration 4g pk, 50~500hz, 3 axes, 30 min * drop test test height 70cm * physical specifications size open frame: 76.2 x 127 x 35.5mm (3 x 5 x 1.4) u-channel: 127 x 80.4 x 38mm (5 x 3.17 x 1.50) weight open frame: 10.25 oz (291g) u-channel: 13.38 oz (380g) notes: 1. a ll measurements should be made directly at the terminals of the power supply. 2. ripple and noise depend upon output voltage a specifed per particular model. 3. isolation for up to 1min duration. 4. specifed for free-air convection cooling. 5. line regulation measured from 90 - 264vac/100vac minimum required for full load start. 6. preset accuracy measured at nominal load, 120vac input. 7. o/p noise measured directly at pins/terminals @ nominal load, 0uf by pass and 47uf electrolytic, pk-pk@ 20mhz bandwidth. special emc notice: the end application shall provide an earth ground connection for conducted & radiated emission performance. astrodyne is not liable for the end application without extra earth connection to pmmk130s open frame power supply. www.astrodynetdi.com astrodyne usa: 1-800-823-8082 astrodyne pacific: 886-2-26983458 pmk130 series 130w open frame and u-channel power supplies with pfc
mechanical dimensions open frame (pmk130s-xx) b1 127mm 5.00in 115.6mm 4.55in 5.7mm .22in 76.2mm 3.00in 66.2mm 2.61in 5mm .20in 4_ 3.5mm .14in pmmk130s-o-tb_b1 33mm 1.3in 2.5mm .10in 1.6mm .06in b1 input connector : 3p / 8.25mm pitch terminal block output connector : 6p / 8.25mm pitch terminal block fg acn acl vo vo vo com com com b height 33mm 2010/5/6 pmmk130s erica 2012/5/2 height labeling changes b1 1 : 2 a4 2d outline drawings rev drawing no. description date sheet metal tolerance (unless otherwise specified) piercing bending angular 300 mechanical dimensions u bracket (pmk130s-xxu) com fg acn acl vo vo vo com com 127mm 5.00in 38mm 1.50in .94in 2.24in 24mm 115.6mm 4.55in .22in 5.7mm 50.2mm 1.98in 40.2mm 1.58in .51in 13mm .47in 57mm .59in 15.1mm 12mm 80.4mm 3.17in www.astrodynetdi.com astrodyne usa: 1-800-823-8082 astrodyne pacific: 886-2-26983458 pmk130 series 130w open frame and u-channel power supplies with pfc
mechanical dimensions - fan placement recommendation www.astrodynetdi.com astrodyne usa: 1-800-823-8082 astrodyne pacific: 886-2-26983458 pmk130 series 130w open frame and u-channel power supplies with pfc
mechanical dimensions open frame (pmk130s-xx-a) 127mm 5.00in 115.6mm 4.55in 5.7mm .22in 76.2mm 3.00in 66.2mm 2.61in 5mm .20in 4_ 3.5mm .14in fg acn acl vo vo vo vo vo com com com 1.6mm .06in 2.5mm .10in 33mm 1.3in com com b1 b1 output connector : 10p / 3.96mm pitch molex 41791-0010 input connector : 5p / 3.96mm pitch molex 41791-0005 pmmk130s-o-m_b b height 33mm 2010/05/06 erica pmmk130s b1 height labeling changes 2012/04/20 1:2 2d outline drawings rev drawing no. description date sheet metal tolerance (unless otherwise specified) piercing bending angular 300 vo fg acn acl com com com com com vo vo vo vo 115.6mm 4.55in 5.7mm .22in 80.4mm 3.17in 50.2mm 1.98in 15.1mm .59in 40.2mm 1.58in 12mm .47in 24mm .94in 13mm .51in 57mm 2.24in 127mm 5.00in 38mm 1.50in mechanical dimensions u bracket (pmk130s-xxu-a) www.astrodynetdi.com astrodyne usa: 1-800-823-8082 astrodyne pacific: 886-2-26983458 pmk130 series 130w open frame and u-channel power supplies with pfc
mechanical dimensions - fan placement recommendation www.astrodynetdi.com astrodyne usa: 1-800-823-8082 astrodyne pacific: 886-2-26983458 pmk130 series 130w open frame and u-channel power supplies with pfc
derate curves www.astrodynetdi.com astrodyne usa: 1-800-823-8082 astrodyne pacific: 886-2-26983458 pmk130 series 130w open frame and u-channel power supplies with pfc
derate curves 3814 www.astrodynetdi.com astrodyne usa: 1-800-823-8082 astrodyne pacific: 886-2-26983458 pmk130 series 130w open frame and u-channel power supplies with pfc
|
